CUSTOM RADIATION PROTECTION,
SHIELDING AND STORAGE
|
|
MarShield™ Lead Blankets MarShield™ has over 30 years of experience in the manufacturing of leaded radiation shielding products. We can advise on various materials to use and can supply any configuration for lead blankets to best address your requirements.
Lead blankets are made using lead wool or lead plate. Lead wool is the preferred material due to its flexibility in handling. It consists of fine strands of lead from .005 to .015 inch diameter, of varying length.
MarShield supplies lead wool products in accordance with Federal Specification QQ-C-40 Type II Grade C. We compact this interlaced wool in a random orientation to ensure consistent attention without streaming.
Since lead wool is by nature less dense than lead plate, the mass equivalence and approximate dose rate reduction for various densities is shown in this table:
|
Lead Wool |
Approx. Finished |
Lead Sheet |
% Dose Rate |
|
Denisty |
Blanket Thickness |
Equivalent Thickness |
Reduction |
|
(lb / sq ft) |
(in) |
(in) |
(60 Co) |
|
10 |
1/2 |
1/8 |
20% |
|
12.5 |
3/8 |
5/32 |
23% |
|
15 |
5/8 |
3/16 |
26% |
|
20 |
3/4 |
1/4 |
31% |
Where greater shielding is required, multiple blankets can be stacked to achieve a linear reduction in dose rate.
All lead blankets are constructed by encapsulating the lead within an inner cover to contain the lead, and then a heavier outer cover for added protection and durability. Materials used for inner and outer covers can be vinyl-laminated nylon, urethane-laminated nylon, or silicon-impregnated fiberglass fabric (for high temperatures.)
Inner covers of lead wool blankets are sewn in a quilted pattern to prevent shifting of the lead wool when blankets are draped or hung. The materials used for inner covers are typically 10 oz. weight, with heat sealed seams or sewn seams as appropriate.
Outer covers are made using heavier weight material (typ. 18 oz.), with edge seams heat sealed or sewn as required. Perimeter grommets are installed on the outer cover border edge to facilitate job site placement or hanging from racks. Number 5 grommets (5/8” ID) at 12” spacing are standard. Grommet size, type and spacing can be as specified by your requirements.
Standard colors for vinyl-laminate materials are yellow or white, with others available upon request. Standard color for high temperature material is gray.
Note: Dimensions indicate size of lead wool “cake.” Outer border edge with grommets extends about 2” beyond lead on all sides. MarShield™ also supplies lead plate blankets in rectangular and Gore (tapered) shapes upon request.